Installing The Qs02 Hdmi Media Streaming - BenQ x3100i User Manual

• Avoid leaving the remote control and batteries in an excessive heat or humid environment like the
kitchen, bathroom, sauna, sunroom or in a closed car.
• Replace only with the same or equivalent type recommended by the battery manufacturer.
• Dispose of the used batteries according to the manufacturer's instructions and local environment
regulations for your region.
• Never throw the batteries into a fire. There may be danger of an explosion.
• If the batteries are dead or if you will not be using the remote control for an extended period of time,
remove the batteries to avoid damage to the remote control from possible battery leakage.

Installing the QS02 HDMI Media Streaming

The supplied QS02 HDMI Media Streaming is an Android TV (ATV) dongle to be used with the
projector. See the instructions below to install the dongle. With a successful installation, you
can enjoy more entertainment programs through this projector.
1. Make sure the projector is turned off and
the power cord is disconnected.
2. Loosen the screws that secure the top of
projector cover
cover 2 3 .
2
8 Introduction
1 . Slide to remove the
1
1
3
3. Plug the USB Micro B cable to the dongle
Plug the dongle to the HDMI* port on the
projector 2 .
*This HDMI port is for connecting QS02 HDMI Media
Streaming only.
1
4. Replace the projector cover, and tighten the
screws.
5. Connect the power cord to the projector and
turn it on. Press
*This is used to hold the USB plug when shipped.
Do not route the cable here.
2
to select Android TV.
1 .