Table of Contents
Advertisement
required. The projected image will be slightly higher/lower than the lens centerline with 125
mm vertical offset.
To optimize your projection quality, we suggest doing the projection by referring to the values listed in the
non-gray rows.
All measurements are approximate and may vary from the actual sizes.
BenQ recommends that if you intend to permanently install the projector, you should physically test the
projection size and distance using the actual projector in situ before you permanently install it, so as to
make allowance for this projector's optical characteristics. This will help you determine the exact mounting
position so that it best suits your installation location.
Installing the adjustment feet for upside down projection
Using the supplied adjustment feet kit to install two additional adjustment feet will help you
project the image upside down.
To install the adjustment feet, turn off the projector and follow the instructions below.
1
4
After the installation is completed, turn the projector upside down.
Power on the projector, the projector will automatically select a suitable setting for the way the
projector is placed. If not, go to Advanced menu - Installation > Projector Position, press OK
and press / to select Auto, Front Ceiling, or Rear Ceiling.
16 Positioning your projector
2
3
Advertisement
Table of Contents
