Advertisement
STEP2.2 : SWASHPLATE MIXING TYPE RECOGNITION
AND ELEVATOR ENDPOINT SETUP
$B22:
+FRRERBRA
BRIERE
With all channels stationary, move the transmitter elevator stick
forward, and then back to center position. This completes the
swashplate mixing type recognization process.
The control unit will determine the CCPM mixing ratio or
traditional mechanicalmixing maximum elevator endpoints.
HBSS
BALE SRAM BDO PARADE)
BARE KO
PAE
+ TRICE
°
3R3GX Flybarless#SCCPM
Rit Hl NS M+ SRAM BARD ATE °
Throttle stick position where main pitch is 0 degree must be
maintained through this setup process.
PUEPABKRERNAROR
AME » RIBEH -
Throttle stick must be maintained/
APERE
00
ELE
0.0
Mode 1
Mode 2)
E.LIM settings
ELIM
3, E.REV ELEVATOR REVERSE SETUP MODE
E.REVHRRREREERARERR
Helicopter tilting
direction
RRANJA
Swashplate correction
direction
+FREESA
Si
Helicopter
direction
MARSA
4. A.LIM AILERON ENDPOINTS SETUP
A.LIMB!
52 17 #2 82 EAN
Press the SET button to enter E.REV setup mode. The E.REV
LED will lit up after E.LIM turns off. This setup mode sets the
elevator gyro direction
1: Tilt the helicopter forward as shown in diagram, and check if
'swashplate is_tilting correctly toward the back.
2. If the swashplate is tilting at the wrong direction, move the
transmitter elevator stick until STATUS LED changes color,
and re-check:the swashplate tilting direction.
ERTSE RM > MEERTEN" E.REV HERIERAERO
IRER »
PCESE-LIMIBIOS, » E.REVIESZRE » HERET eH ACK URB ETE
TUET
HS ORNATE + FaRAs ESOZSE »
2. OR+FRTGISIEBIR » HIRED RACER CLIBS TATUSIE ASH » AR
28+ FRGEHOLS EE
E.REV settings
E.REViRit
Press the SET button to enter A.LIM setup mode. The A.LIM
LED
will lit up after E.REV turns off. With all channels stationary,
move the transmitter aileron stick to the right, and then back to
center position. This completes the aileron endpoint setup
process. The control unit will determine the maximum aileron
endpoints
BAK SEM»
MNT A"A.LIMEIR
TER" EMT > IOFEREV
JBIGR > ALIMIE IER < HESIOD
» CRIES
» TRE
RELE > H3GX Flybarless SEJNI HiFi «
The throttle stick position where main pitch is 0 degree must be
maintained through this setup process.
SEPHESAERS
RRA RORMUE : TIB.
Throttle stick must be maintained
woe
A.LIM settings
ALIM
Advertisement
