Advertisement
STEP1.4 : COLLECTIVE PITCH SETUP
RANA : ENIRE (BABES AE
Adjust the maximum collective pitch using the transmitter's swash
plate mixing function (pitch swash AFR). Recommended pitch range
+42, maximum pitch range for advanced pilot shall not exceed #14 .
AIEEE
+12
: SRPRSRBB+14
AR-
+12 Collective pitch
Do not adjust individual servos endpoints through the servo
ATV/AFR
function, use only swashplate mixing adjustments.
Should any changes made to the endpoints or
trims on the
transmitter in the future, the flybarless system
initial setup must
be performed again.
CCPMARBE
TSB
+ AiR Swasht+
FRR
(Pitch
swash AFR) H
: DABBOSGARSOVATVTIER
>
BRELSOANBUARS
> WAS MET FlybarlessS
ARE -
While using 3GX FBL system, be sure to turn off the
following functions in the transmitter
{EFSGXAME
RERNA FSAI
DE
Example : cyclic pitch of 8:
STEP1.5 : CYCLIC PITCH SETUP
Futaba 12ZH with three BL 700H's
BRAS : IRR
AlLeron swash AFR : 53% (8°)
Swashplate:
lic pitch setting: With the main blades parallel to
Elevator swash AFI
3%
helicopter
ly, throttle stick positioned where main pitch is
Pitch swash AFR : 37% (+12°)
0 degrees, move aileron stick all the way to the right, adjust the
3
3
AIL mixing ratio within radio's SWASH menu so the main blade
Fataba 12ZH 7880 BL 700H x3
mixing ratio in
SWASH menu can be set to the same value as AIL.
N
+ SRR
ERROREA
BPIEPERENRARO
Pitch
h AFR : 37% (412°
MUBHAM
+ HIRE EITAESwash PAILLE » EENE
S H S Mas AER SLR
E I 2 y )
PTE ARATE +O 18 1T2Evash ELELEE
AAAIL LLARABIBN] ©
If adjustments is needed for aileron and elevator roll rate, it can
lone through 3GX interface's flight mode settings, or through
>
Eh
3GX PC interface.
48° Cyclic pitch
-z
SRHLGRRAMRRGRKG
THICKMMMAICXAMTHE
IVE MUI
d
SGX
RS TIE <
Adjustments to the CCPM servos endpoints should be done
through transmitter's swashplate mixing function (AIL swash AFR).
Do not adjust individual servos endpoints through the servo
ATV/AFR
function. Should any changes made to the endpoints or
subtrims on the transmitter in the future, the flybarless system
initial setup must be performed again.
CCPM ARAB
TS MOS + HEP SESWash+
FM RIT BHI
>
DEBS BOMRBVATV TER > MRELSAMAUARS
» Wh
ABUETFlybaressS
ARE
2.E.LIM SWASHPLATE MIXING TYPE RECOGNITION
STEP2.1 : ENTERING E.LIM SETUP MODE
AND ELEVATOR: ENDPOINT: SETUP -
Anie keeping swashplate level and main pitch at zero degrees,
E.LIM-+ FNRA
Ht Bie Ae iT FS MBAS EAT :
press the SET button to register the neutral point and enter E.LIM
setup mode. The E.LIM LED will lit up after DIR turns off.
RG+FRAKE ` RRUBLABLAKEK + BIZ P'SET'
MOIR IE
Si ELIM BERE > EA" ELIMARACTIZR "ERT
©
The throttle stick position where main pitch is 0 degree must
be maintained through this setup process.
OPESAEGKTRR ASSOLE : TIBB -
E.LIM settings
ELIMI?
GE
hey
Advertisement
