Download Print this page

Align 3GX Compact Instruction Manual page 7

Advertisement

FLYBARLESS SYSTEM INITIAL SETUP STEPS
FERRARE
1. DIR : DIRECT MODE TO BYPASS GYRO FOR
MECHANICAL TRAVEL AND NEUTRAL POINT
SETUP
DIRBMTBROUBRER
Orns Ooo
STEP1.1 : ENTER THE DIR SETTINGS
51.1 : ADIRE E
Press and hold the SET button while powering up the receiver.
Release the button when LED 1-5 begin to cycle. Press power
cycle to enter DIR mode. The DIR green LED will light up
indicating the gyro has been bypassed for neutral and
mechanical travel range setup.
IRR SET RAM
WERT
AR"
HBLED1~5(DIR~A.REV) SiG
FRR
ERT AABI
EE) » "DIR"HRIB TEAL + RUE ASGX
Flybarlessiii(JZAPUBRERK ©
Note: If pressed for more than 2 seconds, 3GX will enter 3GX
throttle calibration mode.
Re-power and enter DIR setting.
BE : BiRBWSMVS2H » 3GX SAICA MPHIARERK
BENTA
SEA DIRE ©
DIR settings
DIRBESt
1. When entering setup mode during
power up, 3GX will initiate
startup process. Do not move the
helicopter at this time,
otherwise swashplate will be tilted after start up. Should this
occurs, restart the setup mode.
2. If 3GX was to be mounted inverted, please enter connect anti-
torque compensation section and set it as "reverse" (STATUS
LEI
lock.
turns red); to avoid the effect of the performance of gyro
2, RECAER
TOLER
NGS i EAEAP
ADAE
» MH
1A790008" ZIT (STATUS FEAOKDIS ) » LARA ICM BERR °
Rev.
Aati-torque compensation
Pre ts
Aileron B58
ree at
TRANSMITTER FUNCTION TO SERVO MAPPING 2882M
Adjust subtrims on transmitter
7 so servo horn is horizontally level
BBBOIB ALVIS
BeSubtrim)
STEP1.2 : SWASHPLATE FUNCTION CHECK
DMN.2 : HFR
Verify the correct swashplate movements for PIT, AIL, and ELE inputs.
$@+F A/F) PIT -AIL - ELE ESER - +
DIR settings
DIRS
Ostrvs Ooo
em]
agaa y
a
GiT
E iw
In case of incorrect servo movement or no movement at all,
please check for proper connection between 3GX flybarless
connection to servos, as well as proper setup on transmitter.
SMB
GAR SEMH IE MREIGX Flybarless JRR RIRE
RUREPRBRELZSEE
STEP1.3 : MECHANICAL SETUP
DRA. : RMSE
Adjust the servo neutral point and main blade pitch.
DRED
- EERS
(BT)
Pay extra attention to these setup steps.
Incorrect neutral
points will affect flight stability, and worse lead to loss of
control.
ASRAERRE
SVUBALE
HOVKERIEE
BIRER
KOEI
>

Advertisement

loading

This manual is also suitable for:

Heg3gx01t