Care And Maintenance; Troubleshooting - Scandomestic IC306D Manual

CARE AND MAINTENANCE

MAINTENANCE AND CLEANNESS
Cleaning should be done when needed, to ensure good
performance with the minimum amount of energy
consumption. If the appliance is used in a dirty
environment, it should be cleaned more frequently.
1 Do not open the doors frequently or for too long time
to save energy.
2 Never leave heavy or hot stuff on the top of the
appliance to avoid deforming.
3 Switch off the appliance and remove the plug from the
socket before cleaning.
4 To clean the appliance, please use a soft cloth
dampened in some moderate detergent and hot water.
5 Use warm water to clean oil or fruit juice stain on the
magnetic gasket in order to keep its elasticity. Apply
some talcum powder to it to prolong its service life.
6 If the condenser coil is not cleaned 4 times per year,
the efficiency of the appliance will decrease
significantly.
7 The appliance should not be left unused for a long time,
to stop using the appliance, disconnect the main power
first, then clean the inside and leave the doors open for
2-3 days to dry.
Storing the appliance after shutting
down
NOTICE: Unsuitable room temperature during storage can
damage your property.
Ensure that the room temperature is between -10℃ to
+50℃.
Ensure that the appliance is dry inside and outside.
Correct Disposal of this product
This marking indicates that this product
should not be disposed of with other
household wastes throughout the EU. To
prevent possible harm to the environment or
human health from uncontrolled waste
disposal, recycle it responsibly to promote
the sustainable reuse of material resources. To return your
used device, please use the return and collection systems
or contact the retailer where the product was purchased.
They can take this product for environmentally safe
recycling.
REMARK:
The fuse trip current of the appliance is between 10 and
16A.
The A-weighted emission sound pressure level is below 70
dB(A).
TROUBLE SHOOTING
TROUBLES REASON
Unfreezing *Temperature
control is on the
highest
temperature
point(1 point)
*Plug and outlet
not connected
well
*Fuse broken off
Compressor *Temperature
can not stop control is on the
working lowest
temperature
point(7 point)
*Too much stuff
stored in one
time
*Thick frost
*Too many times
of door-opening
*Too near the
wall
*Near the hot
source or sun
Too warm *Temperature
control is on the
highest
temperature
point(1 point)
*Too much stuff
stored in one
time
*Too many times
of door-opening
*Near the hot
source or sun
Too cold *Temperature
control is on the
lowest
temperature
point(7 point)
Big noise or *Ground is not
flat
Violent
vibration
*Refrigerating
tubes connected
SOLUTION
Adjust
temperature
control
Make both of
them connect
well
Change the fuse
Adjust
temperature
control
Reduce the
quantity
Defrost
Reduce the times
of door-opening
Far from the wall
Change the place
Adjust
temperature
control
Reduce the
quantity
Reduce the times
of door-opening
Change the place
Adjust
temperature
control
Change the place
Separate them