The Function Of Control Panel - Scandomestic IC306D Manual

THE FUNCTION OF CONTROL
PANEL:
Mechanical Thermostat ：
1 The figure on the temperature control 1~7 only means
the temperature level from high to low, not means the
specific temperature.
2 The green light is a power indicator, when it is on, the
power is connected.
Use a special tool (for example, a flat-blade screwdriver) to
turn the knob till the nick pointing to a specific figure (1~7).
Turn the knob clockwise, the temperature inside will go
down, turn the knob in the other direction, the
temperature will go up.
When you turn the knob anticlockwise to "0", the
compressor will stop working.
We recommend the nick pointing to the 6 or 5, to ensure
the food inside the cabinet is frozen effectively.
Do not turn the knob from "7" to "0" or "0" to "7" ！
Electronic thermostat
1 The EMS is electronic controller.
2 The electronic controller has been already set in the
factory.
3 If you need to adjust the electronic controller, please
contact professional service personnel.
STORAGE
1 The appliance is suitable for storing ready-frozen foods.
2 It must not be filled higher than the stacking mark on
the inside of the freezer. (LOADLINE) markings.
3 If there is no load line sticker, please use the top of the
baskets as standard.
DEFROST:
1 Defrost when the frost thickness on the wall of the
cabinet reaches 5mm to optimize the freezing capacity.
2 Turn the temperature control to the lowest point for 6
hours before defrosting.
3 Cut off the power and take out the food, use the
defrost removal, do not apply sharp tools.
4 After defrosting, clean the wall with a dry cloth, and
then power on.
THE FOLLOWING PHENOMENA ARE
NORMAL:
1 There will be the sound of flowing water when the
refrigerant is running.
2 When the environment humidity is too high, there will
be dew condensed on the surface of the freezer.
3 When the appliance is running, the condenser and
compressor will be hot.
INSTRUCTION OF THE LOCK:
• You can lock the appliance: The first step you put the
key and key cylinder into lock hole; The second step
you turn the key rotate90°
key.
• You can unlock the appliance: First step you turn the
key rotate 90° CCW; The second step you put out the
key and key cylinder from lock hole.
REMARK: The lock is one of the options, and your product
maybe haven't.
CW; Then you put out the