Download Print this page

Indiana Line BASSO 840 Owner's Manual page 8

Hide thumbs Also See for BASSO 840:

Advertisement

ALIMENTAZIONE
Collegate l'alimentazione alla pre-
sa utilizzando il cavo in dotazione
e posizionate l'interruttore su ON.
Se il subwoofer è inutilizzato per
lungo tempo, posizionate l'inter-
ruttore su OFF.
Nel caso sia necessario, sostituire
il fusibile con uno di eguale va-
lore, altrimenti la garanzia viene
meno e si potrebbe danneggiare il
subwoofer.
USO
Posizionando il deviatore POWER
su AUTO, il subwoofer entra in
funzione automaticamente in
presenza di segnale (LED verde)
e ritorna in stand-by (LED rosso)
dopo circa quindici minuti di
assenza del segnale stesso.
Posizionando il deviatore POWER
su ON, il subwoofer è sempre in
funzione (LED verde), anche in
assenza di segnale.
SUPPLY
Connect the supply to the socket
by using the supplied power cord
and turn the switch to ON.
If the subwoofer is not used for
long time, put the switch to OFF
position.
If you experience the blown fuse,
replace it with same type one;
otherwisely, the warranty will
expire and the subwoofer can be
damaged.
USE
Setting the switch POWER to
AUTO, the subwoofer automatical-
ly switch-on as soon as a signal
is present (green LED) and turn
to the stand-by mode (red LED)
about fifteen minutes after the
signal is not present.
Setting the switch POWER to ON,
the subwoofer is always working
(green LED), without signal too.
8
INSTALACJA
Podłącz zasilanie do gniazda za
pomocą dostarczonego przewodu
zasilającego i ustaw przełącznik
w pozycji ON.
Jeśli subwoofer nie jest używany
przez dłuższy czas, ustaw przełącz-
nik w pozycji OFF.
Jeśli wystąpi przepalenie bezpiecz-
nika, poproś o jego wymianę na
ten sam typ; w przeciwnym razie
gwarancja wygaśnie, subwoofer
może ulec uszkodzeniu.
UŻYTKOWANIE
Po ustawieniu przełącznika POWER
w pozycji AUTO subwoofer włącza się
automatycznie po wykryciu sygnału
(zielona dioda LED) i przechodzi
w tryb gotowości (czerwona dioda
LED), gdy przerwa w dostarczaniu
sygnału wyniesie około 15 minut.
Po ustawieniu przełącznika POWER
w pozycji ON subwoofer pracuje
w trybie ciągłym (zielona dioda)
także przy braku sygnału.

Advertisement

loading