Safety Instructions For Operation - ROLEC Sinexcel ULTRACHARGE 160 Maintenance Manual

Safety Instructions for Operation

Safety Instructions for Operation
Before using for the first time, you must read this document carefully. Make sure the
equipment is installed and commissioned according to the instructions in the
installation manual.
Do not perform unauthorized modifications to the product. The manufacturer will not
be liable for any consequence caused by the violation of the safety operation
regulations and design, production, and usage standards.
Do not touch the EV charging connector or vehicle inlet, keep it dry and clean.
Do not use this product if the power cord or connector shows any signs of damage.
In case of any abnormal operation or conditions, press the emergency button
immediately to turn off all electrical input and output.
If the emergency button is pressed, the system operator should be informed. The
charging station must not be restarted until the system operation technician resets the
system.
Make sure there is no debris or fluids in the EV charging connector or vehicle inlet.
Do not attempt to connect or disconnect power cables when power is on.
When performing maintenance, turn off the power switch, ensure that electrical
connections are correct, and display warning notices in the area.
Pay attention to the copper wire carries dangerous voltage of equipment, even when
all circuit breakers of the charger are disconnected.
Connect protective earth wire (PE) before connecting neutral line and phase line.
After installation or maintenance, make sure that all doors are correctly secured.
Adaptors or conversion adapters are not allowed be used.
Extension cords are not allowed be used.
UltraCharge 160 DC Charger
Page 7 of 22
EVUCMM-V01R1 Maintenance Manual
October 2023