universalblue KIVU 4026B User Manual page 56

Problem
The appliance
does not work
The device
does not work
properly
The appliance
is cooling more
than expected
The appliance
is not cooling
as expected
Odours come
out of the
device
There is
thawing water
scattered inside
the appliance
and on the floor
A layer of ice
has formed
Condensation
formed on the
outside of the
device
Make sure that the device is correctly plugged in, that the fuse is not
blown or that a power failure has not occurred.
The room temperature is too low. Try adjusting the camera
temperature to a cooler level to solve this problem.
It is normal for the freezer not to operate during the automatic
defrost cycle or for a short period of time after the appliance is
turned on to protect the compressor.
The temperature knob it may be at the maximum position.
If you have placed food that contains a lot of moisture under the
cooling vents, remove the food from the area.
The food may be too close which will block the air circulation. You
may have placed hot foods or too many foods inside the refrigerator.
The door may not be closed correctly. The rubber on the door may be
damaged. The refrigerator may not be ventilated. There may not be
enough free space between the top and side spaces of the
refrigerator and other surfaces.
The temperature regulator may not be positioned correctly.
The interior may need to be cleaned.
Any food, container or wrapping is in poor condition and causes
odors.
Make sure that the tube and drain hose are not blocked. Make sure
that the drainage compartment is correctly positioned.
Check that the air outlets are not blocked by food and make sure that
the food is placed in a way that allows sufficient ventilation. Make
sure the door is completely closed. To remove frost, see the cleaning
and care chapter.
This can happen when humidity is high, during cold seasons, for
example. The phenomenon is the same when cold water is placed in
a glass, and it does not represent any problem. Wipe with a dry cloth.
Solution
56