universalblue KIVU 4026B User Manual page 57

The
temperature of
the device is
too high/low
You hear a
noise
The side panel
of the
refrigerator is
hot
Motor works
continuously
The water drip
on the floor
Light does not
work
High: You may have left the doors open too long or too often; or the
doors are held open by an obstacle; or the appliance is located with
insufficient space on the sides, back and top.
Lower: increase the temperature by following the steps in the
"DISPLAY" section.
It It may be the noise of coolant passing through the tubes. It's not a
problem.
Compressor running noise.
Air movement noise from the fan motor in the freezer or other
compartments.
Gurgling sound similar to boiling water.
Clicking noise during the
defrosting.
Clicking noise before the compressor starts.
Other unusual noises are due to the reasons listed below and may
require you to check and take action:
The unit is not level.
The back of the unit is touching the wall.
Dropped or rolling bottles or containers.
This will happen when the door opens or closes frequently, when it is
put into operation in the appliance or when the appliance operates
during the summer with a high outside ambient temperature. In this
case, do not touch the panel, as this results from the concentrated
heat inside the structure and does not represent any problem.
It's normal to hear the sound of the engine often, plus it will need to
work harder when it does:
The set temperature is colder than necessary
A large amount of hot food is fed into the device.
The room temperature is too high.
The doors have been left open for a long time or they open and close
continuously.
After installing the appliance or if it has been switched off for a long
period of time
The water tank (located at the bottom rear of the appliance) may not
be correctly positioned to collect water, or the water spout is blocked.
You may need to remove the cooler from the wall to check the
container and outlet pipe.
The LED light may be damaged. Follow the instructions in the section
"Cleaning and maintenance".
The control system may have deactivated it because the doors have
been open for a long time. Close and open the door to reactivate the
light.
57