Related Manuals for SystemAir fantech CSF4
Summary of Contents for SystemAir fantech CSF4
- Page 1 Installation, Operations, and Maintenance instruction CSF4 Crawlspace Ventilation Fan...
-
Page 2: Table Of Contents
Table of contents 1 Introduction ............. 1 Product Description ........1 Intended Use..........1 Document Description ........1 Fantech Warranty........... 1 Product Overview ........... 1 Name Plate ........... 1 1.6.1 Type Designation ....... 2 2 Safety ..............2 Safety definitions..........2 Safety Instructions.......... -
Page 3: Introduction
Introduction Product Overview Product Description This product is made to pull stale air from non-conditioned areas, such as a non-encapsulated crawlspace, to bring fresh air in. This fan has rotating parts and personnel must exercise safety precautions during installation, operations, and maintenance. Intended Use Use this product only in the manner intended by Fantech. -
Page 4: Type Designation
1.6.1 Type Designation Safety Product Name CSF4 #79415 and CSF4 Safety definitions #79415A Warnings, cautions and notes are used to point out specially Duct Collar Dimensions in in- important parts of the manual. 4 (102) ches (mm) Warning Motor Type AC: Alternating Current, 1–phase If you do not obey these instructions, there... -
Page 5: Personal Protective Equipment
• Ducted exhaust fans must always be released to the Installation outdoors • Install screen guards within 7 feet (2.1 meters) from the To Install the Product working area of the product. Using supplied hardware with FC 4 Mounting Clamps •... -
Page 6: Electrical Connection
Electrical connection Note: All product motor and capacitor connections are prewired To do before the electrical from the factory. connection Note: • Make sure that the electrical connection agrees with the product specification on the motor name plate. There are two open ports on the terminal strip: Neutral (white wire) and Line (black wire). -
Page 7: Troubleshooting
Troubleshooting With Motor Speed Controller Problem Cause Solution Refer to section 4.3 Wiring Diagrams. Then, White (N) Blue Supply Motor do a check of the Voltage Black (L) Black Incorrect wiring Leads 115V wire connections Brown to make sure they Capacitor Speed Control are correctly... -
Page 8: Maintenance
Maintenance Warning Set the service disconnect switch in the OFF position before you do maintenance unless the instructions tell you differently. Make sure that the switch is not accidentally set in the ON position. To Maintain the Product Note: Because the product bearings are sealed and provided with an internal lubricating material, no additional maintenance is necessary. - Page 10 last page Canada Latin America (800) 747 1762 (800) 565 3548 +52 55 1328 7328 support@fantech.net support@fantech.net support@fantech.net © Copyright Fantech All rights reserved Fantech reserves the rights to alter their products without notice. This also applies to products already ordered, as long as it does not affect the previously agreed specifications.
Need help?
Do you have a question about the fantech CSF4 and is the answer not in the manual?
Questions and answers