Fisher & Paykel DishDrawer DD60 Service Manual page 50

F8X: Motor Controller Faults
F82 fault: Motor Controller ADC Check Failure
F84 fault: Fill Valve Drive Failure
F85 fault: Bridge Temperature Sensor
F86 fault: Motor Bridge Failure
F87 fault: Motor Controller Current Sense Error
1 Replace the motor controller
F9X: Wash Controller Faults
F95 fault: Fan Control Failure
1 Replace the drying fan and wash controller in the tub faulting
F96 fault: Detergent Diverter Control Failure
1 The detergent diverter component is drawing current when turned off. Replace the
wash controller in the tub faulting.
F97 fault: Rinse Aid Pump Control Failure
1 This fault indicates that a component is drawing current when the product is turned
off. Replace the wash controller in the tub faulting.
F98 fault: Water Softener Brine Pump (water softener models only)
1 This fault indicates that the component is not off. Replace the wash controller in the
tub faulting.
F99 fault: Water Softener Bypass Valve (water softener models only)
1 The fault indicates that the component is not off. Replace the wash controller in the
tub faulting.
FCX: Communication Faults
FC0 fault: Motor Controller COMMS Fault
FC1 fault: Wash Controller COMMS Fault.
1 Run a rinse cycle on both tubs. Does the product operate correctly?
2 Is the harness between the wash controller & motor controller damaged?
3 Replace the damaged harness. Does this clear the fault?
4 Change the wash controller. Does this clear the fault?
5 Replace the motor controller.
FCx: Communication Faults
FC3 fault: Inter - Wash Controller COMMS Fault.
This fault indicates that the top tub wash controller cannot communicate with the
bottom tub.
1 Is the bottom tub wash controller harness damaged or disconnected?
2 Replace the bottom tub wash controller
Err fault: Inter-Wash Controller COMMS Fault
This fault indicates that the top tub wash controller cannot communicate with the
bottom tub.
1 Is the bottom tub wash controller harness damaged or disconnected?
2 Replace the bottom tub wash controller
7 FAULT DIAGNOSTICS
Yes No
>>1
>>1
>>1
>>1
>>1
>>A
Yes No
>>A
>>A
>>A
>>A
>>A
Yes No
>>A >>2
>>3 >>4
>>A >>4
>>A >>5
>>A
Yes No
>>A >>2
>>A
Yes No
>>A >>2
>>A
49