Table of Contents
Advertisement
NL Set up and connect
Connect the water inlet hose to the
1.
tap (26.4 mm = 3/4").
Open the tap carefully and check
2.
that the connections are tight.
Water drainage connection types
The information will help you connect this
appliance to the water outlet.
PAY ATTENTION!
When draining, the water drain hose is
under pressure and can come loose
from the installed connection position.
The water drain hose against un-
▶
intended to secure loosening.
Remark: Observe the pumping
heights.
The maximum pumping height
d
washbasin
16
The connection position
tie with a
hose clamp
(24-40 mm) bore
gene.
the water drainage
feeding hose with
a bend
→ Page 31
fixate and
gene.
plastic stand
pipe with rubber
run muff or a
floor drain
4.6 Adjusting the device
To reduce noises and vibrations and
to prevent the device from walking,
adjust the device horizontally.
Loosen the lock nuts with a SW17
1.
open-end wrench.
the water drainage
feeding hose with
a bend
→ Page 31
fixate and
gene.
Advertisement
Table of Contents
