Table of Contents
Advertisement
NLSet up and connect
Connect the water inlet hose to the
2.
tap (26.4 mm = 3/4").
Open the tap carefully and check
3.
that the connections are tight.
Water drainage connection types
The information will help you connect this
appliance to the water outlet.
PAY ATTENTION!
When draining, the water drain hose is
under pressure and can come loose
from the installed connection position.
▶
Secure the water drain hose against
unintentional disconnection.
Remark:Observe the pumping
heights.
The maximum pumping height bed
washbasin
16
The connection position
tie with a
hose clamp
(24-40 mm) bore
gene.
the water drainage
feeding hose with
a bend
→
Page 29
fix
honor and
ge
n.
plastic stand
pipe with rubber
run muff or a
floor drain
4.6 Adjusting the device
To reduce noises and vibrations and to
prevent the device from walking, place
the device horizontally.
Loosen the lock nuts with a SW17
1.
open-end wrench.
the water drainage
feeding hose with
a bend
→ Page 29
fixate and
gene.
Advertisement
Table of Contents
