Table of Contents
Advertisement
washbasin
plastic stand
pipe with rubber
run muff or a
floor drain
4.7 Adjusting the device
To reduce noises and vibrations and to
prevent the device from walking, place
the device horizontally.
Loosen the lock nuts with a SW17
1.
open-end wrench.
The connection position
tie with a
hose clamp
(24-40 mm) bore
gene.
the water drainage
feeding hose with
a bend
fixate and
gene.
the water drainage
feeding hose with
a bend
fixate and
gene.
Set up and connect NL
To adjust the appliance, turn the
2.
appliance feet. Check the horizontal
adjustment of the appliance with a
spirit level.
All appliance feet must be firmly
planted on the floor.
Tighten the lock nuts against the
3.
housing with an open-end wrench
SW17 hand-tight.
Hold the appliance foot while
doing so and do not adjust the
height.
4.8 Connecting the appliance
electrically
Insert the mains plug of the
1.
mains cable of the device into a
socket in the vicinity of the
device.
The connection data of the device
can be found in the technical data
→ Page 55 .
17
Advertisement
Table of Contents
