Malfunction
flashes.
burns.
Cause and Troubleshooting
The detergent drawer is not closed as far as it will go.
Push the detergent drawer into the appliance as far as it will go.
▶
ready.
Pump unit is not installed.
Place the pump unit in the detergent drawer.
1.
→ "Cleaning the detergent drawer",
Page 41
Push the detergent drawer into the appliance as far as it
2.
will go.
The voltage monitoring system detects an
impermissible voltage drop.
No solution possible.
▶
Remark: When the supply voltage has stabilized, the
program continues normally.
Undervoltage can cause a program extension.
No solution possible.
Detergent dosage is too high.
Immediate measure: mix a tablespoon of fabric softener
▶
ter with 0.5 l of water and pour this mixture into
the manual dosing compartment (not for outdoor,
sportswear and down textiles).
When the intelligent dosing is activated, re-
▶
then induce the basic dosing amount
→ Page 36.
When dosing manually, reduce to the full
▶
next wash with the same load, the amount
ness detergent.
Temperature is too high.
Wait for the temperature to drop.
▶
→ " program cancel", Page 33
▶
Water level is too high.
Start the program Pump down .
▶
Laundry is wedged in the door.
Open the door again.
1.
Remove trapped laundry.
2.
Close the door.
3.
To start the program, press
4.
Troubleshooting NL
.
47