Table of Contents
Advertisement
NL Troubleshooting
Malfunction
Washing water is not
pumped out.
No water flows into
the device. The
detergent was not
washed in.
Start several times
with centrifugation.
The program duration
changes during the
wash cycle.
50
Cause and Troubleshooting
Mount the water drain hose at a maximum of 1 meter
▶
height.
Detergent dosage is too high.
Immediate measure: mix a tablespoon of fabric softener
▶
ter with 0.5 l of water and pour this mixture into
the manual dosing compartment (not for outdoor,
sportswear and down textiles).
When the intelligent dosing is activated, re-
▶
then induce the basic dosing amount
→ Page 36.
When dosing manually, reduce to the full
▶
next wash with the same load the amount of
detergent.
Unauthorized extension mounted on the water drain
hose.
Remove any unauthorized extensions from the
▶
water drain hose. Connect device
was not pressed.
Press .
▶
z
eef in the water supply is clogged.
Clean the strainer in the water supply.
▶
Water tap is closed.
Open the water tap.
▶
Water supply hose is kinked or pinched.
Make sure that the water inlet hose is not
▶
nods or clenches.
The imbalance control system eliminates the
imbalance by distributing the laundry several times.
No error - no action required.
▶
Remark: When loading, place large and small items of
laundry together in the drum. Different sized laundry
is more evenly distributed during the spin cycle.
The program sequence is electronically optimized. This
can lead to changes in the program duration.
No error - no action required.
▶
The imbalance control system eliminates the
imbalance by distributing the laundry several times.
No error - no action required.
▶
Advertisement
Table of Contents
