Contec IPC Series Operational Manual page 71

5 Add this line
[ 14.119897] Netfilter messages via NETLINK v0.30.
[ 14.140366] ip_set: protocol 6
[ 23.105846] tun: Universal TUN/TAP device driver, 1.6
[ 23.105852] tun: (C) 1999-2004 Max Krasnyansky <maxk@qualcomm.com>
[ 23.126582] device virbr0-nic entered promiscuous mode
[ 23.598979] virbr0: port 1(virbr0-nic) entered listening state
[ 23.599004] virbr0: port 1(virbr0-nic) entered listening state
[ 23.599095] IPv6: ADDRCONF(NETDEV_UP): virbr0: link is not ready
[ 23.776942] virbr0: port 1(virbr0-nic) entered disabled state
[ 5535.891742] fuse init (API version 7.22)
[ 6059.844266] usb 1-5.2: new high-speed USB device number 5 using xhci_hcd
[ 6059.930411] usb 1-5.2: New USB device found, idVendor=058f, idProduct=6366
[ 6059.930419] usb 1-5.2: New USB device strings: Mfr=1, Product=2, SerialNumber=3
[ 6059.930423] usb 1-5.2: Product: Mass Storage Device
[ 6059.930427] usb 1-5.2: Manufacturer: Generic
[ 6059.930430] usb 1-5.2: SerialNumber: 058F0O1111B1
[ 6059.966307] usb-storage 1-5.2:1.0: USB Mass Storage device detected
[ 6059.967346] scsi host2: usb-storage 1-5.2:1.0
[ 6059.967988] usbcore: registered new interface driver usb-storage
[ 6059.970331] usbcore: registered new interface driver uas
[ 6060.971859] scsi 2:0:0:0: Direct-Access
[ 6060.972656] sd 2:0:0:0: Attached scsi generic sg1 type 0
[ 6062.790993] sd 2:0:0:0: [sdb] 15728640 512-byte logical blocks: (8.05 GB/7.50 GiB)
[ 6062.791664] sd 2:0:0:0: [sdb] Write Protect is off
[ 6062.791670] sd 2:0:0:0: [sdb] Mode Sense: 03 00 00 00
[ 6062.792213] sd 2:0:0:0: [sdb] No Caching mode page found
[ 6062.792220] sd 2:0:0:0: [sdb] Assuming drive cache: write through
[ 6062.798855] sdb:
[ 6062.800729] sd 2:0:0:0: [sdb] Attached SCSI removable disk
66
Multi Flash Reader
BX-956S CentOS7.3 64bit Operational Check Manual
1.00 PQ: 0 ANSI: 0