Table of Contents
Advertisement
TYRE PRESSURE LOSS WARNING
– after using the tyre inflation kit.
– after switching the wheels of the
same axle (you must not switch
between the front and rear wheels).
It should always be done after
checking the tyre pressure of all four
tyres when cold.
Tyre pressures must correspond to the
current usage of the vehicle (empty,
carrying a load, motorway driving,
etc.).
Resetting procedure
Ignition on, vehicle stationary :
– press button B. briefly several times
to select the function "SET TYRE
PRESSURE" is displayed on the
Instrument panel.
– press and hold (around 3 seconds)
button B to start initialization. If the
"SET
" warning light flashes or
text message in Instrument
panel"TPMS ONGOING" for
approximately 5 seconds accompanied
by a constant illumination of the "SET
" warning light, this indicates that
the request for reinitialization of the
tyre pressure reference value has
been correctly registered.
Reinitialization is carried out after a
few minutes' driving.
Readjustment of tyre pressures
The tyre pressure must be adjusted
when the tyres are cold.
If the tyre pressures cannot be
checked when the tyres are cold, the
recommended pressures must be
increased by 0.2 to 0.3 bar (3 PSI).
Never deflate a hot tyre.
After each reinflation or readjustment
of the tyre pressure, launch the
reinitialisation of the tyre pressure
reference value.
Inflate tyres and reset
The
1 warning light comes on
along with
. 2 is displayed in red
This indicates that at least one tyre is
flat or punctured.
In the event of a flat tyre, inflate the
relevant tyre.
In the event of a puncture, change the
tyre or consult an authorised dealer.
It is not recommended to drive the
vehicle if a tyre is punctured. This may
cause tyre to damage. Refer chapter
�� 117.
Check and readjust the pressure of the
four tyres when cold, and launch the
3
D r i v i n g - 6 7
Advertisement
Table of Contents
