Mitsubishi Electric s-AIRME-G02 Instructions For Installation, Use And Maintenance Manual page 45

The lifting gear and accessories must be in good condition and must be prepared, installed, maintained, monitored, checked,
tested, operated and used in accordance with the manufacturer's instructions, the rules of good practice and the domestic laws
and regulations that apply.
The lifting equipment and/or ropes and/or other lifting accessories to be fitted between the lifting device and the load (chains,
slings, hooks, sling bars) are not provided by the manufacturer.
Operators lifting and/or transporting the unit or the individual packages (the customer, the freight forwarder and/or the installer)
must only choose and use lifting accessories that comply with European regulations, and/or national regulations of the country
of use.
The accessories must be in good condition and subjected to regular controls, checks, and maintenance, in accordance with the
manufacturer's instructions, as well as European regulations and national laws of the country of use.
It is mandatory to use suitable lifting equipment that can withstand the total weight of the load to be lifted and is compliant with
the domestic laws and regulations that apply.
It is mandatory to ensure the suitability of the lifting accessories which must be chosen on the basis of the loads to be lifted and
the lifting procedures, avoiding excessive tension of the ropes, slings and chains and avoiding use of the accessories outside
the limit load for which they were designed and built.
Make sure, in particular, that the ropes, slings and chains remain at an angle at which the load on each rope, sling or chain can
be kept below its limit load.
The use of inappropriate lifting equipment may result in injury to the personnel involved in the operation and/or damage to the
unit.
In case of lifting with helicopter, pay particular attention to the "sealing" of the openings on the machine. It is essential that there
are no areas where air can enter the unit.
During the flight, the flow of air into the machine at high speed could cause the various panels to break with repercussions also
in terms of safety.
Failure to observe the above and any harm caused to persons, animals or property relieves the manufacturer of all liability.
Before handling the machine, carefully read the following instructions.
WARNING:
All the unloading, handling and positioning operations must be carried out using appropriate means and by
experience personnel, trained and authorised for such activities.
Installation, use and maintenance manual 45