Page 2
User Manual L N G - P R N - 0 1 3 7 Document Information This table describes the version and release date. Description Version Author Date Liu Huan 03/10/2022 First release Liu Huan 04/01/2023...
Under no circumstances shall any part of this user manual be copied, reproduced, translated, or sold. This manual is not intended to be altered or used for other purposes unless otherwise permitted in writing by Vantron. Vantron reserves the right of all publicly-released copies of this manual.
Clean with a damp cloth Do not try to clean exposed electronic components unless with a dust collector Power off and contact Vantron technical support engineer in case of the following faults: - The Product is damaged - The temperature is excessively high...
Page 7
LNG-PRN-0137 User Manual (HW) Precautions for Battery This battery cannot mix with deposal or twice- recycled batteries in use. Otherwise, for its abnormal charge and discharge, it will cause over-heated, distort, smoke or burning. Cette batterie ne peut pas se m é l anger avec des batteries deposal ou deux fois recycl é e s en cours d ’...
LNG-PRN-0137 User Manual (HW) Overview Thank you for choosing Vantron. It is our commitment to provide our valued customers with the state-of-the-art embedded devices and the best product services. As per request from the customer, we provide LNG-PRN-0137 that runs Yocto linux system based on intel Pentium N4200 with a customer logo on the glass cover.
LNG-PRN-0137 User Manual (HW) LNG-PRN-0137 Hardware Instructions LNG-PRN-0137 is developed based on Intel Pentium N4200 series. Product Appearance and Interfaces Figure 3-1, Figure 3-2, and Figure 3-3 show the top view, bottom view, and front view of the Product. Figure 3-1 Top view...
Page 10
LNG-PRN-0137 User Manual (HW) Figure 3-2 Bottom view...
Page 11
LNG-PRN-0137 User Manual (HW) Figure 3-3 Front view...
LNG-PRN-0137 User Manual (HW) Features The features of Vantron LNG-PRN-0137 are listed in Table 3-1. Table 3-1 Features Features ® Processor: Intel Pentium™, N4200, Quad core, 2.5GHz (Max) ■ ■ LPDDR4 2133MHz 8GB ■ 1 x M.2 2280 SSD Slot, 1 x SATA 1 x LVDS ■...
LNG-PRN-0137 User Manual (HW) Interface Description This chapter describes the hardware features, including switch, jumper, connector and PIN functions. The interface description is based on the connector sketch map. Necessary information such as pictures are attached. Type-C connector Name Type...
LNG-PRN-0137 User Manual (HW) Name Type Description VBUS_3 POWER 20V SBU2 VBUS_4 POWER 20V SSRX1_N SSRX1_P GND4 POGO pin definition Table 4-1 and Table 4-2 describe the valid signal of connector on the LNG-PRN-0137 board. Name Type Description Power POWER 20V...
LNG-PRN-0137 User Manual (HW) Hardware Operation Notes Power preparation: Please confirm the power input is 20V and the current is 2.25A as recommended. Our adapter is applicable to this device only. Do not insert any third-party equipment. We do not assume any liabilities for any damages caused therefrom.
LNG-PRN-0137 User Manual (HW) Disposal and Product Warranty Disposal When the device comes to end of life, you are suggested to properly dispose of the device for the sake of the environment and safety. Before you dispose of the device, please back up your data and erase it from the device.
Page 19
Any Product found to be defective and covered under warranty pursuant to Clause above, shall be returned to VANTRON only upon the CUSTOMER’s receipt of and with reference to a VANTRON supplied Returned Materials Authorization (RMA) number. VANTRON shall supply an RMA, when required within three (3) working days of request by the CUSTOMER.
Page 20
LNG-PRN-0137 User Manual (HW) FCC compliance statement this device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.
Page 21
LNG-PRN-0137 User Manual (HW) http://www.fcc.gov/oet/ea/fccid/. Please use the device FCC ID number for search. To maintain compliance with FCC RF exposure requirements, the use of belt clips, holsters and similar accessories should not contain metallic components in its assembly, the use of accessories that do not satisfy these requirements may not...
Page 22
LNG-PRN-0137 User Manual (HW) (1)l’appareil ne doit pas produire de brouillage, et (2) l’appareil doit accepter tout brouillage radioélectrique subi, même si le brouillage est susceptible d’en compromettre le fonctionnement. La bande 5150–5250 MHz est réservée uniquement pour une utilisation à l’intérieur afin de réduire les risques de brouillage préjudiciable aux systèmes de satellites mobiles...