Sony HT-DDW840 Operating Instructions Manual page 4

About This Manual
The instrucbons in this manual al_ for models
HT-DDW840 and HT-DDW74Ik Check your model
number by looking at the lower right comer of tl_e
front panel. In dfis manual, the HT-DDW840 is used
for illustration purpose mdess stated otherwise. Any
dit_rence in operation is clearly indicated in the texL
for example, "HT-DDW840 only".
The HT-DDW840 consists of:
- Receiver STR-K840P
Speaker system
• FmnI/surround speakers SS-MSP2
• Center speaker SS-CNP2
• Sub woot_r SA-WMSP4
The HT-DDW740 consists of:
- Receiver STR-K740P
Speaker system
• From/surround speakers SS-MSP2
• Center speaker SS-CNP2
• Sub woot_r SA-WMSP2
About area codes
The al_a code of lhe receiver you pUl_hased is
shown on Ihe lower portion of the rear panel (see
tl_e illustration below).
Any differences in operation, according to the
area code, ale clearly indiczted in tile text, for
example, "Models of area code AA only".
Till
The ins{ructions in this manual describe die controls
On the receiver.
You can also use the conIrols on the
supplied remote if they have the same or similar
names as those on _he receiver, For details on the use
of your remote, see pages 39 - 45 for RM-PP41 !
(HT-DDW840 only) and pages 46 49 for RM-U306
(HT-DDW740 only).
Note for the supplied remote
For RM-PP411 (HT-DDW840 only)
The VIDEO 3, TV/SAT, PHONO, AUX,
SOURCE, MPX/DUAL, ANALOG DIRECT,
12 and ON SCREEN buttons on the remote _we
not available.
For RM-U306 (HT-DDW740 only)
The MULTI CH button on the remote is not
available.
Demonstration Mode
The demonstration will activ3te _he filet time you
turn on lhe power. When lhe demonstration sta_s,
the following message appears in lhe display:
"NOW DEMONSTRATION MODE IF
YOU FINISH DEMONSTRATION
PLEASE PRESS POWER KEY WHILE
THIS MESSAGE APPEARS IN THE
DISPLAY THANK YOU"
TO cancel the demonstration
Press I/(_ to turn the receiver off while the above
message is being displayed. The next time you
mm the receiver on, the demonstration will not
appear.
TO view the demonstration
Hold down SET LIP and pl_sS I/_ to turn on tl_e
towel\
Notes
Running the demonstration will clear lhe
receiver's memory. For details on what will be
cleal_d, see "Clearing the receiver's memol2€"
on page 15.
There will be no sound when tl_e demonstration
mode is activaled.
YOU cannot cancel demonslration if you did not
press I/(D while the above message is being
displayed. To cancel demonstration after tl;e
above message appears, press I/(_) twice to
activate the demonstration again. Then, press
I/(D while the aNwe message is being
displzyed.
4GB