Sony HT-DDW840 Operating Instructions Manual page 20

Multi channel surround setup
(continued)
Adjusting the speaker level
Use the remote while seated in your listening
position to adjust the level of each speaker.
Note
The receiver
incorpor3tes a new test tone with a
frequency centered at 800 Hz for easier speaker level
adjustment.
1
Press I/_) to turn on the receiver.
2
Press TEST TONE on the remote.
"T. TONE" appears in the display and you
will hear the test tone from each speaker in
sequence+
3
Adjust the LEVEL parameters so that
the level of the test tone from each
speaker sounds the same when you are
in your main listening position.
Press LEVEL to adjust the balance and
level of speakers. For details on the LEVEL
menu, see page 28.
While adjusting, the test tone is output from
the speaker whose adiustment is performed.
4
Press TEST TONE again to turn off the
test tone.
Tip
YOU can adjust the level of all speakers at the same
time. Tam MASTER VOLUME on the main unit or
press MASTER VOL 4-/- on the lemote.
Notes
• Tile lest tone cannot be output when the leceiver is
set to MULTI CH IN (HT+DDW840 only).
• The adjusted value ale shown in the display during
adjustmenL
• Although these adjustments can also be made via
the front panel using the LEVEL menu (when the
test tone is output, the receiver switches to the
LEVEL menu automaticMly), we lecommend you
_llow the procedure described above and adjust the
speaker levels from your listening position using lhe
remote.
Listening to the subwoofer
FOWER POWER indicator
First, turn down the volume on the receiver.
The volume should be set to minimum before
you begin pl_ying the programme source.
1
Turn on the receiver and select the
programme source.
2 Press POWER on the subwoofer.
The POWER indicator on the subwool_r
lights up in green.
3
Play the programme source.
Adjusting the sound
Slight adjustments to the system can enhance
your sound enjoyment.
Adjusting the subwoofer
LEVEL
1 Rotate LEVEL to adjust the volume.
Set the volume level to best suit your
preference according to the progr_unme
source.
Note
DO not turn the volume of the woofer to maximum.
Extraneous noise may be heard.
20G8