Sony HT-DDW840 Operating Instructions Manual page 31

Before receiving broadcasts, make sure you
have connected FM and AM antennas to the
receiver (page 7).
Notes
• Do not press any button on the receiver or supplied
remote during autobetical operation.
• If you move Io another al_a, l_peat this procedure
lo store stations in your new area.
• For details oll tuning the slol_d stations, see
page 33.
• If you move the antenna at]er storing stations with
this procedure, the stored settings may no longer be
valid, If this happens, repeat this procedure to store
the stations again.
(Models of area code CEL, CEK only)
This function lets you store up to 30 FM and
FM RDS stations in alphabetical order without
redundmlcy. Additionally, it only stores the
stations with the clearest signals.
If you want to store FM or AM stations one by
one, see "Presetting radio stations" on page 33.
1 Press I/_) to turn off the receiver.
2 Hold down MEMORY and press I/_) to
turn the receiver back on.
"AUTO-BETICAL SELECT" appears in
the display and the receiver scans and stores
all the FM and FM RDS stations in the
broadcast area.
For RDS stations, the tuner first checks lbr
stations broadcasting the same program,
then stores only the one with the clearest
signal. The selected RDS stations are sorted
alphabetically by their Program Service
n_une, then assigned a 2-character preset
code. For more details on RDS, see page 34.
Regular FM stations _we assigned
2-character preset codes and stored after the
RDS station.
When done, "FINISH" appears in the
display momentarily _md the receiver
returns to the normal operation.
You can enter a frequency of the station you
want directly by using the numeric buttons on
the supplied remote. For details on the buttons ,11
used in this section, see pages 39-45 for remote
RM-PP411 and pages 46-49 for remote •
RM-U306.
=
t Press TUNER on the remote, el
The last received station is tuned in.
o.
2 Press FM* or AM* to select the FM or o
AM band.
3 Press D. TUNING on the remote.
4 Press the numeric buttons to enter the
frequency.
Example 1: FM 102.50MHz
(9-®-®-®-®
Example 2: AM 1350 kHz
(You don't have to enter tbe last "t)" when the
tuning scale is set to 10 kHz.)
If you cannot tune in a station and the
entered numbers flash
Make sure you've entered the right
frequency. If not, repeat steps 3 _md 4.
if the entered numbers still flash, the
frequency is not used in your _ea.
* For models of area code CEL, CEK: FM/AM.
continued
31GB