Led Error Messages; Image Problems - Vivitek D803W User Manual

DLP Projector—User's Manual

LED Error Messages

E C
RROR ODE
Ready to power on (Standby)
System Warm up
Lamp Lit , System stable
Cooling
Over Temperature
Thermal Break Sensor error
Lamp Fail
Lamp over voltage
Input voltage too high
Temp too high
Asymmetry detected
Lamp under voltage
Input voltage too low
Axial Fan error
Blower Fan error
DMD Fan error
Case Open
Color wheel error
Ballast communication error
In the event of an error, please disconnect the AC power cord and wait for one (1) minute before restarting
the projector. If the Power or Lamp LEDs are still blinking or any other situation that isn't listed in the chart
above , please contact your service center.

Image Problems

Problem: No image appears on the screen
1. Verify the settings on your notebook or desktop PC.
2. Turn off all equipment and power up again in the correct order.
Problem: The image is blurred
1. Adjust the Focus on the projector.
2. Press the Auto button on the remote control.
3. Ensure the projector-to-screen distance is within the 10-meter (33-feet) specified range.
4. Check that the projector lens is clean.
Problem: The image is wider at the top or bottom (trapezoid effect)
1. Position the projector so it is as perpendicular to the screen as possible.
2. Use the Keystone button on the remote control to correct the problem.
Problem: The image is reversed
Check the Projection setting on the Installation I menu of the OSD.
Problem: The image is streaked
M
ESSAGES
P LED
OWER
G
REEN
ON
Flash
ON
Flashing
－
4 blinks
－
5 blinks
5 blinks
5 blinks
5 blinks
5 blinks
5 blinks
6 blinks
6 blinks
6 blinks
7 blinks
9 blinks
10 blinks
— 40 —
L LED
AMP
R
ED
－
－
－
－
－
－
ON
1 blinks
2 blinks
3 blinks
4 blinks
5 blinks
6 blinks
1 blinks
2 blinks
3 blinks
－
－
1 blinks
T LED
EMP
R
ED
－
－
－
－
ON
－
－
－
－
－
－
－
－
－
－
－
－
－
－