Troubleshooting
Troubleshooting
Manual Test Mode
Manual Test Mode Commands
Table 3. Manual Test Commands
Key Sequence
*#06#
IMEI Check
*#**372#
Test Display. Melody, speaker, keypad, etc.
42
Motorola ZN200 telephones are equipped with a manual test mode capability. This allows
service personnel to verify functionality and perform fault isolation by entering keypad
commands.
To enter the manual test command mode, a GSM/DCS/PCS test SIM must be used.
1.
Press and hold
to turn the phone OFF.
2.
Remove the battery door as described in the procedures.
3.
Remove the battery as described in the procedures.
4.
Remove the customer's SIM card from the phone.
5.
Insert the test SIM into the SIM slot.
6.
Replace the battery as described in the procedures.
7.
Replace the battery door as described in the procedures.
8.
Press and hold
to turn the phone ON.
Test Function/Name
July 03, 2008
Remarks
No Test Mode Required