Electrolux 900 SteamPro User Manual page 73

Step 7 Clean the glass panel with water
and soap. Dry the glass panel care‐
fully. Do not clean the glass panels
in the dishwasher.
Step 8 After cleaning, do the above steps
in the opposite sequence.
Step 9 Install the smaller panel first, then the larger and the door.
Make sure that the glasses are inserted in the correct position otherwise the surface of the door
may overheat.
11.12 How to replace: Lamp
WARNING!
Risk of electric shock.
The lamp can be hot.
Step 1
Turn off the oven. Wait until the
oven is cold.
Top lamp
Step 1 Turn the glass cover to remove it.
Step 2 Remove the metal ring and clean the glass cover.
Step 3 Replace the lamp with a suitable 300 °C heat-resistant lamp.
Step 4 Attach the metal ring to the glass cover and install it.
Side lamp
Step 1 Remove the left shelf support to get ac‐
cess to the lamp.
Step 2 Use a Torx 20 screwdriver to remove
the cover.
Step 3 Remove and clean the metal frame and
the seal.
Before you replace the lamp:
Step 2
Disconnect the oven from the
mains.
Step 4
Step 5
Step 6
Step 3
Put a cloth on the bottom of the cav‐
ity.
Replace the lamp with a suitable 300 °C
heat-resistant lamp.
Install the metal frame and the seal.
Tighten the screws.
Install the left shelf support.
ENGLISH 73