Technical Safety Instructions; Maintenance And Storage - Bestway Rapid Rider Manual

Non-compliance with these operating instructions may expose you to serious danger.
• ATTENTION! NO PROTECTION AGAINST DROWNING!
• SWIMMERS ONLY!
• Evenly distribute loads when use the product. Tipping and drowning may occur with uneven distribution of
loads.
SAVE THESE INSTRUCTIONS

TECHNICAL SAFETY INSTRUCTIONS

Read the manual and follow the instructions relating to safety tips, correct and complete product assembly,
setting into service, use and maintenance.
For your own safety, always heed the advice and warnings in these instructions.
Only use the product in the places and conditions for which it is intended.
• Full inflate all air chambers.
• Passenger numbers and load weight shall by no means exceed passenger number and maximum weight
capacity in specifications.
• This product should not be used as life saving device.
• Life saving device (life jacket and life buoy) must be prepared together and inspected.
• Keep away from flames and fires.
• Before every use, carefully inspect all product components, to ensure everything is in good condition and
tightly secured. Please stop to repair if you find any damage.
• Be careful when landing on the ground. Sharp and rough objects such as rocks, cement, shells, glass, etc.
may punctured the product.
• Don't leave the product exposed to sun for long periods of time, as high temperatures shall give rise to air
expansion, which can cause irreparable damage.
• Never leave in or near the water when not in use.
ASSEMBLY
WARNING: Adult assembly required.
Take the product and accessories out with care. Spread the product out.
WARNING: Poles contain fiber glass. We strongly recommend wearing gloves during assembly to avoid
irritating hands.
Due to the high elasticity of the sunshade, open it carefully to avoid injury.
INFLATION
1. Open safety valve and inflate with the air pump (not included) to design working pressure on the product.
2. Fill the chambers until most of the wrinkles are gone and it feels firm to touch but NOT hard. If you use a
pressure gauge (not included), the pressure should not exceed the specified pressure on the product or in
the instructions. Do not over-inflate the product. Only use a low-pressure air pump. Do not use an air
compressor.
NOTE: Under and over-inflation of the product will result in safety hazards. It is better to check the pressure
of the product each time before using.
3. Be sure to close the valves after inflation, press in the safety valves after inflation.
NOTE: Never stand on or rest objects on the product during inflation.
DEFLATION AND DISMANTLING
1. Dismantle the sunshade from the product.
2. Open and pinch the bottom of the valves to deflate.

MAINTENANCE AND STORAGE

1. After use, use a damp cloth to gently clean all surfaces.
NOTE: Never use solvents or other chemicals that may damage the product.
2. Store in a dry place, with a temperature higher than 15ºC/59ºF, out of reach of children.
WARNING
9