Removal/Assembly Of Side Panels; Electric Connection; Connection To The External Thermostat - Cadel VERA 7.0 Installer Manual

5.5

REMOVAL/ASSEMBLY OF SIDE PANELS

To disassemble the side panels, proceed as follows:
• Undo the front screws (see Fig. 21).
• Open the side panel (see Fig. 22) and release the rear teeth (see Fig. 23).
• To assemble, proceed in reverse order.
Fig. 21 - Remove the screws
5.6

ELECTRIC CONNECTION

Warning: the appliance must be installed by an authorized technician!
• The electric connection occurs through a cable with plug put in an electric socket which is able to support charge and tension
specific of every model, as described in the technical datas table (see FEATURES a pag. 24).
• The plug must be easily accessible when the appliance is installed.
• Please further assure you that your network is endowed with an efficient earth connection: if it does not exist or if it is not
efficient, please endow you with one in compliance with the law.
• Connect the supply cable first on the back of the stove (see Fig. 24 Fig. 25) and then at a wall electric socket.
Fig. 24 - Electric socket with master switch
• Do not use extension cables.
• If the feeder cable is damaged, it must be replaced by an authorized technician.
• When the stove is not going to be used for a long period of time, it advisable to remove the plug from the socket on the wall.
5.7

CONNECTION TO THE EXTERNAL THERMOSTAT

The stove works through a thermostat probe placed in its inner. If you desire, the stove can be connected to an external room
thermostat. This operation must be executed by an authorized technician.
Connect the wires from the external thermostat to the "Term opt" terminal on the stove board. Activate the external thermostat
(default setting OFF) as indicated below:
16
Fig. 22 - Rotate side panels Fig. 23 - Remove side panels
Fig. 25 - Plug connected
VERA7 /7.0/UP - INDIGO EVO / INDIGO EVO 7