Maintenance - GiBiDi SERRA321 Instructions For Installation Manual

SERRA321

MAINTENANCE

Periodically check the gate structure, in particular:
• Check functioning of the hinges;
• Check that the leafs are correctly balanced. Excessive inclination of the leafs will result in faster wear of the
operator fastening brackets. Do the test by unlocking the operator and checking that the leafs do not move
on their own;
• Check good functioning of the safety devices;
• Unlock the operator and check that there are no points of friction along the entire travel;
• Check that there is no dirt or debris on the worm screw, and if so, clean and then lubricate the worm screw with
lubricating grease.
• Periodically check proper adjustment of the operator thrust force and the efficiency of the unlocking device for
manual operation (see the relative paragraph).
• The safety devices installed on the system must be checked every six months.
Gi.Bi.Di. Srl reserves the right to change the technical data without prior notice in relation to product development.
MALFUNCTIONING
For any unresolved malfunction, cut the power to the system and call in a qualified technician (installer). In the
period when the gate is out of service, activate the manual unlocking device to allow manual opening and
closing.
The manufacturer:
declares that the products:
ELECTROMECHANICAL LINEAR OPERATORS SERRA321
are in conformity to the following Directives:
2014/30/EU;
2014/35/EU;
and that the following harmonised standards have been applied:
IEC 60335-1:2010+A1:2013+A2:2016
Ÿ
IEC EN6100-6-1;
Ÿ
EN 61000-6-2:2005;
Ÿ
EN 61000-6-3:2007+A1:2011;
Ÿ
Date 10/05/23
Declaration of conformity EU
GI.BI.DI. S.r.l.
Via Abetone Brennero, 177/B,
46025 Poggio Rusco (MN) ITALY
The legal Representative
Michele Prandi
19
UK