Placement; Alignment - Sub-Zero IW30LH Installation Manual

IN S TA L L AT I O N

Placement

CAUTION
Before moving the unit into position, secure the door/
drawers closed and protect any finished flooring.
Use an appliance dolly to move the unit near the opening.
The front leveling legs are extended below the front rollers to
improve stability during placement. Once the unit is placed
in front of the opening, completely retract the front leveling
legs to allow the unit to be rolled into position. The front and
rear leveling legs can be adjusted from the front once the
unit is positioned.
If the unit has been on its back or side, it must stand upright
for a minimum of 24 hours before connecting power.
Plug the power cord into the grounded outlet and roll the
unit into position. Verify the anti-tip bracket is properly
engaged.
8 | Sub-Zero Customer Care 800.222.7820

Alignment

LEVE LIN G
Once the unit is in position, the height adjustment can be
made from the front. Using a Phillips drive, turn clockwise to
raise the unit or counterclockwise to lower. Use the lowest
torque setting when using a power drill. Do not turn the
leveling legs by hand. Refer to the illustration below.
When the unit is properly leveled, door/drawer adjustments
are less likely to be necessary.
IMPORTANT NOTE: Level the unit to the floor, not the sur-
rounding cabinetry. This could affect the operation of the
unit, such as door closing.
WARNING
To reduce the possibility of the unit tipping forward, the
front leveling legs must be in contact with the floor.
FRONT
ADJUSTMENT
REAR
ADJUSTMENT
Leveling