Sub-Zero IW30LH Installation Manual page 15

Hide thumbs Also See for IW30LH:

Use and care manual (44 pages)

Table of Contents

Available languages

IN S TA L L AT I O N

Completion

KI C K P L AT E I NS TA L L AT I O N

Position the kickplate and install using the two mounting

screws. Refer to the illustration below. Kickplate must

be removable for service. The floor cannot interfere with

removal.

A maximum 6"

decorative kickplate can be attached

(152)

to the factory-installed kickplate. The two rows of vented

louvers can be covered if the door panel is a minimum 4"

from finished floor.

(102)

To install a decorative kickplate, remove the paper backing

from the magnets and attach the decorative kickplate to the

magnets. The magnets allow the decorative kickplate to be

removed if necessary.

Turn power on by touching "power" on the control panel.

90 ° DO O R S T O P

A 105° door stop is built into the hinges. To limit the door

swing to 90°, open the door slightly less than 90°, then use

a standard screwdriver blade to remove the existing clips

from each hinge. Locate the 90° clips from inside the plastic

bag containing the product literature, then insert the 90°

clips onto each hinge. Refer to the illustration below.

MAGNET

SCREW

Kickplate installation

Sub-Zero, Sub-Zero & Design, Sub-Zero & Snowflake Design, Dual Refrigeration, The Living Kitchen, Great American Kitchens The Fine Art of Kitchen Design, Wolf, Wolf &

Design, Wolf Gourmet, W & Design, red colored knobs, Cove, and Cove & Design are registered trademarks and service marks of Sub-Zero Group, Inc. and its subsidiaries.

All other trademarks are property of their respective owners in the United States and other countries.

CLIP

90° door stop

WATER FILTER B YPASS

If the water filtration system will not be used, it can be

placed in water filter bypass mode by removing the water

filter. Follow these steps to remove the water filter:

Pull out on the bottom edge of the access door and tilt

upward.

To remove the filter, rotate counterclockwise one-quarter

turn, then pull out. Refer to the illustration below.

WARNING