Sub-Zero IW30LH Installation Manual page 13

PANE L I NS TA L L AT I O N
Panel Installation
D R AWE R PA NE L S —TA L L MO D E L
Place the panel face down on a protected work surface.
Position the template flush with the top and sides of the
panel. Verify the correct side of the template is being used,
then mark and drill holes. Refer to the illustration below.
Use a Torx drive to partially insert a #8 x
second hole from the top on each side of the panel. The
screws should be approximately
and will support the weight of the panel during installation.
Align the support screws on the back of the panel with the
slotted holes on both drawer mounting brackets. Refer to
the illustration below. Opening the drawer slightly may help
with alignment. Once the panel is supported by the screws,
partially insert a #8 x 1 / " screw into the second hole from
2
the bottom on each side of the panel, but do not tighten.
TOP OF DRAWER PANEL
TOP OF
DRAWER PANEL
TOP HOLES
FOR UPPER
AND LOWER
DRAWERS
Drawer panel template—top
BOTTOM
HOLES FOR
LOWER
DRAWER
BOTTOM
HOLES FOR
UPPER
DRAWER
7021340
1
/ " screw into the
2
3 / " proud of the panel
(4)
16
BACK OF
DRAWER PANEL
Drawer panel mounting
PAN EL AD J U STM EN T
Close the door/drawers, now adjustments can be made to
align the panels and reveals.
For side-to-side adjustment, move the panels side to side,
then install and tighten all mounting screws.
For up-and-down and in-and-out adjustments, slightly
loosen the bracket screws. Depending on the level of
adjustment required, it may be helpful to loosen all of the
bracket screws which will allow for maximum adjustment.
Once the bracket screws are loosened, use a wrench to
rotate the cams to make adjustments. After the adjustments
have been made, tighten all bracket screws. Refer to the
illustrations below.
IN-AND-OUT
CAM
BRACKET
SCREWS
In-and-out adjustment
BRACKET
SCREWS
UP-AND-DOWN
CAM
Up-and-down adjustment
subzero.com | 13