90° Door Stop; Placement - Sub-Zero Designer Series Installation Manual

Site Preparation
90° Door Stop
The door stop pins provided with the unit limit the door
swing to 90°.
IMPORTANT NOTE: If a 90° door opening is desired, the
pins must be installed prior to installing the unit into the
opening.
To install, open the door to approximately 80°. Insert one
pin into each hinge. Refer to the illustration below.
DOOR STOP PIN
90° door stop
8 | Sub-Zero Customer Care 800.222.7820

Placement

CAUTION
Before moving the unit into position, secure the door
closed and protect any finished flooring.
WARNING
When positioning the appliance, ensure the supply
cord is not trapped or damaged.
Use an appliance dolly to move the unit near the opening.
If the unit has been on its back or side, it must stand
upright for a minimum of 24 hours before connecting
power.
Plug the power cord into the grounded outlet and slide
the unit into position. Verify the anti-tip bracket is properly
engaged.