Table of Contents
Advertisement
9. Transducer installation
9.1 Select the installation position
To avoid the measuring pipe not under low liquid level conditions, please install the transducer
until reaching the constant full-load position being marked in the pipe (Fig. 1).
Upward vertical flowing
➢
During the using process, care should be used to prevent the gas from entering. If bubbles
exist in the fluid, it will affect the measuring stability (Fig. 2).
Water flowing
direction
Upward inclined flowing
Gap
Water flowing
direction
(Fig. 1)
(Fig. 2)
16
Lowest point in the pipe system
The liquid may not be fully
filled in the pipe.
Advertisement
Table of Contents
