Advertisement
M JOB Key
This is the key used to enter the Job mode.
The Job mode offers 6 different jobs which are used mainly for editing. Pressing
this key enters the Job mode, which means you are able to select the desired job
number using the INC key
(3
or the DEC key (93 .
(2 SAVE Key
Use this key when you want to enter the Save mode.
Press the
SAVE
key when storing data received from the equipment connected
to the MIDI IN termina! (6) on the rear panel. This will place the unit in the Save
mode and enable data storage.
(3 LOAD/YES
Key
This key is used to enter the Load mode.
When you want to send
data recorded on a disk back to external equipment, i.e.
when you want to "load" it, press this key. The unit will be set to the Load mode,
enabling data transfer to the connected equipment.
In addition, this key is also used to execute JOB commands.
(9 INC Key
This is one of the keys used to specify file numbers, etc. Pressing this key once
increases the value displayed in single steps. (In other words, it specifies the next
file, etc.)
When
the value reaches the largest number, the loop will start again from the
smallest.
(9 DEC Key
This is the other key used to specify file numbers.
Pressing this key once decreases
the value displayed in single steps. (In other words, it specifies the preceding file.)
When the smallest number is reached, the loop will start again from the largest.
Advertisement
