Advertisement
If several large-volume data messages have been consecutively stored in a single
Setting the Load Time
file, errors may occur on the receiving side when a load operation is carried out
Interval for Multiple
since the receiving equipment is not able to deal with such a large amount of data
at once. In such cases, before loading it is best to set a certain time interval between
Data (JOB 2:
the data messages being transmitted. To do so, use job 2, Interval Time.
|
INTERVAL TIME)
* Interval time can be set in 100ms steps
between 0 and 1,900ms (1.9 seconds).
* The default value (= the setting when power is turned on) is 100ms. If loading
cannot be performed properly with this value, gradually increase the interval time
in single steps (200ms, 300ms, and so on) and try again.
1
Press the JOB key to enter Job mode.
2
Select job 2. To do so, press
the INC or DEC key until the display alternately
shows "Job" and "2".
3
Press the YES key to obtain the interval time display.
Pressing YES alternately displays...
Present interval time
q
(0 - 19)
Alternately
0...0ms 19...1,900ms
displayed
Time
TEN
i
..a
"T"-symbol
indicating
time
and
the present interval time.
4
Use the INC and DEC keys to set the required interval time.
21
Advertisement
