HOMCOM A90-128 Instructions Manual

HOMCOM A90-128 Instructions Manual

Multi-functional mute hydraulic handrail treadmill

Advertisement

Multi-functional Mute Hydraulic Handrail Treadmill
A90-128
Instructions of Multi-functional Mute Hydraulic Handrail Treadmill

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the A90-128 and is the answer not in the manual?

Questions and answers

Subscribe to Our Youtube Channel

Summary of Contents for HOMCOM A90-128

  • Page 1 Multi-functional Mute Hydraulic Handrail Treadmill A90-128 Instructions of Multi-functional Mute Hydraulic Handrail Treadmill...
  • Page 2 Please keep this manual in a safe place for reference. It is important to read this entire manual before assembling and using the equipment. Safe and efficient use can only be achieved if the equipment is assembled, maintained and used properly.
  • Page 3 Product Details Electronic meter*1 Electronic meter base*1 Handrail*1 Upper pipe*1 Lower pipe*1 Main engine*1...
  • Page 4 Product Installation Diagram 5. Connect the induction thread to the thread of the electronic meter, and insert the electronic meter into the base as shown in the picture. 4. Insert the electronic meter base into the upper pipe as shown in the picture and stuck it.
  • Page 5 Using Instructions Electronic Display Function Description Scan: automatically show each function parameter in sequence Time: from 0 to 99: 59 Calorie: accumulating calorie consumption when exercising, only for reference, can not be referred as medical parameter Counting: accumulating the times of steps The step speed rate in one minute Mode: can select every function button, if pressing continuously for 3 seconds, all parameters are zeroed and recounting again.
  • Page 6 Start the Exercise Important prompt: please put the treadmill on the flat and stable ground, it is suggested to put a mat under it in case of damaging the ground after long time using the treadmill. First step: stand on the ground at the back of the treadmill, put your left leg fully on the left tread and step down until it touches the bottom Second step: put your right leg fully on the right thread.
  • Page 7 Trouble Shooting Troubles Solutions Treads 1. This problem is usually exerted because of long time use. The step can’t resistance exerting heat will result in slow rotation. If needing the treads rotated to rotate flexibly again, just wait the oil cylinder to cool down. smoothly 2.

Table of Contents