Using The Timer - Prem-I-Air Elite EH1460 Instructions For Use Manual

If the "WATER FULL" indicator
The water should be disposed of down a drain.
To avoid the need to empty the water, a permanent drain tube may be
Always switch off using the on-off switch on the control panel, NOT by
switching off at the mains socket. This is so that the appliance can allow
the gas pressures to equalise.
Unplug the appliance from the mains when not in use.
The timer can set the unit to run for a selected time (between ½ and 24
hours) and then turn OFF.
Or, it can set the unit to wait for a selected time (between ½ and 24
hours) before turning ON.
To select timed turn-off press the timer button whilst the unit is switched
ON. Then, whilst the display is flashing, adjust the time using the
t
buttons for the number of hours' delay before switching off.
To select timed turn-off press the timer button whilst the unit is switched
OFF (connected to the mains supply but switched OFF using the ON/OFF
lights, the condensate water tank is
full. This should only happen very rarely, as most
of the water collected is evaporated and sent
down the exhaust air tube.
To empty the water, switch the unit off by
pressing the ON/OFF button, wait for three
minutes, and then disconnect from the mains
supply. Place a drainage pan underneath the
drain outlet plug (an the bottom of the unit, at the
back in the centre). Withdraw the bung, and allow
the water to drain into the drainage pan. Replace
the bung, and reconnect the unit to the mains
supply.

USING THE TIMER

Page 6
fitted as shown: use a
piece of 18mm diameter
tube (not supplied) and
run the pipe to a drain,
making sure that it runs
downhill all the way.
s
and