Advertisement
Setting the warning limit:
The low and high warning limits can be set to different values for each sensor. The push
button switch on the front of the display is used for setting the warning limit. The procedure for
setting the warning limit is as follows:
1. Hold the switch while you turn the key on. The display should light up and show "WARNING"
"SETUP".
2. Release the switch. The display should show "SENDERS" "FOUND" and a number indicating the
number of senders detected. This number should match the number of senders connected to the
BIM-19. Only senders that are connected can have their warning points set. (if 00 is shown, check
the BIM and sender connections and then momentarily press the switch)
3. Momentarily press the switch. The display will show the first sender label and its ID #.
4. Each time the switch is momentarily pressed it will go to the next sender.
5. When the desired sender is shown, press and hold the switch. When the lower section of the display
blanks, release the switch.
6. The display will now show "WARN" "LOW" and the current low warning point (0 – 252).
7. Each time the switch is momentarily pressed the low warning point will increase.
8. When the desired low warning point is displayed, press and hold the switch. When the text blanks,
release the switch.
9. The display will now show "WARN" "HIGH" and the current high warning point (48 – 300).
10. Each time the switch is momentarily pressed the high warning point will increase.
11. When the desired high warning point is displayed, press and hold the switch. When the text blanks,
release the switch.
12.
The display will now go back to the sender selection screen in step 4. You can select another
sender to set or turn the key off to exit setup.
MAN# 650447:A
Advertisement
