Advertisement
Quick Links
PERFORMANCE SPEEDOMETER/TACHOMETER COMBO
MOUNTING:
The gauge requires a round hole 3-3/8" in diameter. It should be inserted into the opening from the front and the U-
clamp will be installed from the back. Tighten the two nuts on the U-clamp so that the gauge is secure.
GAUGE SETUP AND CALIBRATION
The setup menus are entered by holding the switch in while turning the key on. The menus are as follows:
Main Menu
Sub Menu
S
PEED
AUTO
ADJ
UNIT
OUTPUT
SERVICE
TACH
ENGINE
WARN
UPDATE
SIGNAL
INFO
MODEL
VER
PPM
GEAR
AUTO
MANUAL
DONE
Series II
ODYR-01-6 & SLX-01-6
Description
auto calibrate speed
adjust calibrate speed
select mph or kph units (MPH / KPH)
speed output selection (2K PPM / 4K PPM)
miles to service setting
set engine cylinder setting
set rpm shift warning point
set rpm update rate for digital readout
select normal or low voltage tach signal (NORMAL / LO VLT)
Gauge model number
Gauge revision code
speed cal setting
transmission gear display selection
automatic transmission with GSS or no indicator
program gear display for manual transmission
restart system with new settings
MAN# 650089B
Advertisement
Related Manuals for Dakota Digital Odyssey II Series
Summary of Contents for Dakota Digital Odyssey II Series
- Page 1 Series II ODYR-01-6 & SLX-01-6 PERFORMANCE SPEEDOMETER/TACHOMETER COMBO MOUNTING: The gauge requires a round hole 3-3/8” in diameter. It should be inserted into the opening from the front and the U- clamp will be installed from the back. Tighten the two nuts on the U-clamp so that the gauge is secure. GAUGE SETUP AND CALIBRATION The setup menus are entered by holding the switch in while turning the key on.
- Page 2 The tachometer is adjustable from 1 to 15 cylinder signals and calibration is discussed below. Diesel engines will usually require a diesel tach adapter DSL-1 or DSL-2, available from Dakota Digital, Inc. The bar displays rpm x1000.
- Page 3 SPEEDOMETER SETUP Press and hold the switch while turning the key on and starting the engine. Once the engine is running, release the switch. When “SPEED” is displayed, press the switch again and then release it. The message display should switch between “AUTO”, “ADJUST”, “UNIT”, “OUTPUT”, and “SERVIC”. METRIC SELECTION If you are setting the system up for metric displays, press the switch when “UNIT”...
-
Page 4: Tachometer Setup
GEAR INDICATOR SETUP This gauge can optionally display the gear position for automatic or manual transmissions. For automatic transmissions, Dakota Digital sender GSS-2000 or higher is required. For manual transmissions, the gauge can learn the positions based on speed and rpm. - Page 5 FUNCTION SWITCH The function switch on the front of the speedometer allows access to all of the mileage, rpm, and performance information. Pressing and releasing the function switch toggles through the different displays. The display sequence is as follows: SPEED MENU ODOMTR >...
-
Page 6: Troubleshooting Guide
Any action for breach of any warranty hereunder, including any implied warranty of merchantability, must be brought within a period of 24 months from date of original purchase. No person or representative is authorized to assume, for Dakota Digital, any liability other than expressed herein in connection with the sale of this product.