Table of Contents
Advertisement
OTR (One Touch Recording)
This function enables you to set a recording length sim¬
ply by pressing RECORD/OTR button on the TV/VCR.
Make sure
...
• Power must be turned on.
• Insert a cassette tape with its erase prevention tab in
place. (If necessary, rewind or fast forward the tape
to the point at which you want to begin recording.)
NOTErThis function cannot be done by the remote con¬
trol.
1 Select the channel to be recorded
Press the number buttons on the remote control or the
CHANNEL ▼ or ▲ button.
2
^
foTRia 301
Begin OTR
Press RECORD/OTR button on
the TV/VCR as many times as
needed. The recording length
will be determined by the num¬
ber of times you press RECORD/OTR button.
Each additional push will increase the recording time by
30 minutes. It is set up to 8 hours.
Push(es)
Display
Recording length
1 push
(normal recording)
2 pushes
0:30
30 minutes
3 pushes
1:00
60 minutes
i
1
i
17 pushes
8:00
480 minutes
HINTS:
• Recording starts immediately when the REC/OTR
button is pressed.
• When REC/OTR button is pressed 18 times, the
TV/VCR will switch to the Normal Recording mode.
• To stop the OTR operation, press STOP button on the
TV/VCR or on the remote control.
• To show the remaining time, press DISPLAY button
repeatedly until "OTR" appears on the TV screen.
• Recording stops when 0:00 is reached.
• Please note that in the SLP mode maximum record¬
ing time, assuming the tape is started at the begin¬
ning, is 8 hours using T-160 (or 6 hours using T-120).
• If the tape runs out before the end time, the TV/VCR
will switch to the Stop mode immediately, eject the
tape and the TV/VCR power will be turned off.
COPYING A VIDEO CASSETTE
(Requires another VCR)
You can make copies of video tapes made by friends or
relatives for your enjoyment.
WARNING: Unauthorized recordings of
copyrighted video tapes may be an in-
fringement of copyright laws.
Connectyour TV/VCR and a Source (Playing) VCR us¬
ing the following diagram.
[The TV A/C R]
[Ex: Source (Playing) VCR]
1) Insert a pre-recorded video cassette into the Source
(Playing) VCR.
2) Insert a blank video cassette, or one you want to re¬
cord over, into the TV/VCR's cassette compartment.
3) Press SPEED button to select the desired recording
speed (SP, LP or SLP).
4) Press CHANNEL ▲ or ▼ button repeatedly so that
"AUX" appears on the screen.
5) Begin playback of the tape in the Source (Playing)
VCR.
6) Press RECORD button on the TV/VCR.
NOTE: For best results during dubbing, use the
TV/VCR's front panel controls whenever possible. The
remote control might affect the Source (Playing) VCR's
playback operation.
-23-
EN
6K27
Advertisement
Table of Contents
