Table of Contents
Advertisement
PREPARATION FOR USE
ANTENNA/CABLE
CONNECTIONS
VIIF/UUF COMBINED ANTENNA
The VHF/UHF Rod Antenna (not supplied) is detach¬
able. Push the stem of the antenna into the hole which
is located on the upper back cabinet of the unit.
Connect the VHF/UHF Rod Antenna or VHF/UHF
Combination Antenna to the ANT. terminal of the
TV/VCR as shown in the diagram below.
For the best reception, extend the VHF/UHF Rod An¬
tenna fully and adjust its position. (Avoid handling the
top section when making adjustments.)
NOTE:
Before plugging the Rod antenna into antenna terminal,
check that the pin is not bent. If it is bent, straighten the
pin as illustrated, then plug the pin into antenna terminal.
Bent pin
(Needs to be straightened)
(Straight pin)
VHF/UHF Antenna
VHF/UHF SEPARATE ANTENNAS
In some areas it will be necessary to use an outdoor an¬
tenna.
VHF Antenna
Flat twin-lead cable
CABLE WITHOUT CONVERTER/
DESCRAMBLER BOX
Use this connection if your cable system connects di¬
rectly to your TV/VCR without a converter box.
With this connection you. 1) can use your TV/VCR Re¬
mote Control to select channels, 2) program one or more
unscrambled channels for Automatic Timer Recording.
From Cable System
75-ohm
Note to CATV system installer:
This reminder is provided to call the CATV system installer's attention to Article 820-40 of the NEC that
provides guidelines for proper grounding and, in particular, specifies that the cable ground shall be connected
to the grounding system of the building as close to the point of cable entry as practical.
-
10
-
EN
6L24
Advertisement
Table of Contents
