Advanced Network Settings - Grandstream Networks GSC3510 Series User Manual
Hide thumbs
Also See for GSC3510 Series:
- Quick installation manual (4 pages) ,
- User manual (88 pages) ,
- Quick installation manual (26 pages)
Table of Contents
Advertisement
OpenVPN® Port
The network port for the OpenVPN® server. By default, it is set to 1194.
OpenVPN®
Determines network protocol used for OpenVPN®: UDP or TCP.
Transport
OpenVPN® CA file (ca.crt) required by the OpenVPN® server for authentication purposes. Press "Upload" to upload the
OpenVPN® CA
corresponding file to the device.
OpenVPN® Client
OpenVPN® Client certificate file (*.crt) required by the OpenVPN® server for authentication purposes. Press "Upload" to
Certificate
upload the corresponding file to the device.
OpenVPN® Client
The OpenVPN® Client key (*.key) required by the OpenVPN® server for authentication purposes. Press "Upload" to upload the
Key
corresponding file to the device.
The cipher method of OpenVPN®, must be the same cipher method used by the OpenVPN® server. Available methods are:
Blowfish
AES-128
OpenVPN® Cipher
Method
AES-256
Triple-DES
Default is "Blowfish"
OpenVPN®
OpenVPN® authentication username (optional).
Username
OpenVPN®
OpenVPN® authentication password (optional).
Password
Advanced Network Settings
Advanced
Network
Settings
DNS Refresh
Configures the refresh time (in minutes) for DNS query. If set to "0", the phone will use the DNS query TTL from DNS server
Timer (m)
response.
DNS Failure
Configures the duration (in minutes) of previous DNS cache when DNS query fails. If set to "0", the feature will be disabled. Note:
Cache Duration
Only valid for SIP registration.
(m)
IPv4 Preferred
Sets the preferred DNS server 1 for the user.
DNS 1 Server
IPv4 Preferred
Sets the preferred DNS server 2 for the user.
DNS 2 Server
Enables the LLDP (Link Layer Discovery Protocol) feature on the device. If it is set to "Yes", the device will broadcast LLDP PDU to
Enable LLDP
advertise its identity and capabilities and receive same from a physical adjacent layer 2 peer. The default setting is "Yes".
Configures the interval the device sends LLLD-MED packet.
LLDP TX Interval
The default setting is 30s.
(s)
Note: Reboot the device to make changes take effect.
Advertisement
Table of Contents
