Connect To Wi-Fi Network - Grandstream Networks GSC3510 Series User Manual

Static IPv6
Enter the static IPv6 address in "Statically configured" IPv6 address type.
Address
IPv6 Prefix
Enter the IPv6 prefix length in "Statically configured" IPv6 address type. Default is 64.
Length
802.1x Mode
Enables and selects the 802.1x mode for the device. The supported 802.1x modes are: EAP-MD5, EAP-TLS and EAP-PEAP.
802.1x mode
The default setting is "Disable".
802.1x Identity Enters the identity information for the selected 802.1x mode. (This setting will be displayed only if 802.1 X mode is enabled).
802.1x Secret Enters the secret for the 802.1x mode. This option will appear when 802.1x mode is EAP-MD5 or EAP-PEAP.
CA Certificate Uploads the CA Certificate file to the device. (This setting will be displayed only if the 802.1 X mode is enabled)
Client Certificate Loads the Client Certificate file to the device. (This setting will be displayed only if the 802.1 X TLS mode is enabled)
Private Key Loads the private key file to the device. (This setting will be displayed only if the 802.1 X TLS mode is enabled)
Bluetooth
Bluetooth Settings
Visible to Nearby Bluetooth Devices
Visibility timeout
Bluetooth PIN
Device Name
Paired devices
Wi-Fi Settings

Connect to Wi-Fi Network

Users can connect wirelessly to a network using Wi-Fi under GSC3510/GSC3505 Web GUI
to a network using Wi-Fi, please, refer to the following steps:
1. Go to GSC3510/GSC3505 Web GUI
2. Enable Wi-Fi Function by turning the option on.
3. Click on Scan to show the list of Wi-Fi networks available around the GSC3510/GSC3505
Note
The list of Wi-Fi Networks refreshes automatically every 15 seconds and user can force to refresh by clicking again on "Scan".
Starting from firmware 1.0.3.8, the GSC3505/GSC3510 support IPv6 over WI-FI.
Enable or Disable Bluetooth on GSC3510/GSC3505
Enable the GSC3510/GSC3505 to be visible via Bluetooth by nearby devices.
Configures visibility timeout to nearby devices before turning back to invisible mode. Default is 2 minutes.
Set up a 6 digits PIN Code. The PIN is required when pairing other Bluetooth devices.
Configures the name that will be shown to other Bluetooth devices.
Lists paired devices.
Press to unpair/remove the device from the list.
�� Network Settings �� Wi-Fi Settings
�� Network Settings
�� Wi-Fi Basics.
�� Wi-Fi Settings. In order to connect