Table of Contents
Advertisement
Administrator's Guide
1. Access Web Config and select the Network tab > Wi-Fi Direct.
2. Select Disable for Wi-Fi Direct.
3. Click Next
4. Check the message, and then select OK.
Disabling Wi-Fi from the Control Panel
When Wi-Fi is disabled, the Wi-Fi connection is disconnected.
1. Tap
on the home screen.
2. Select Router.
The network status is displayed.
3. Tap Change Settings.
4. Select Others > Disable Wi-Fi.
5. Check the message, and then start setup.
6. When a completion message is displayed, close the screen.
The screen automatically closes after a specific length of time.
7. Close the Network Connection Settings screen.
8. Press the
button.
Disconnecting Wi-Fi Direct (Simple AP) Connection from the Control Panel
Note:
When Wi-Fi Direct (Simple AP) connection disabled, all computers and smart devices connected to the printer in Wi-Fi
Direct (Simple AP) connection are disconnected. If you want to disconnect a specific device, disconnect from the device
instead of the printer.
1. Tap
on the home screen.
2. Select Wi-Fi Direct.
The Wi-Fi Direct information is displayed.
3. Tap Start Setup.
4. Tap Change Settings.
5. Select Disable Wi-Fi Direct.
6. Tap the Disable the settings.
Solving Problems
49
Advertisement
Table of Contents
