Connecting To Lan - Epson SureColor SC-P5300 Administrator's Manual

Administrator's Guide
Setting the Proxy Server
Set up the proxy server if both of the following are true.
❏ The proxy server is built for Internet connection.
❏ You want to update the printer firmware via the Internet from the printer's control panel or Web Config.
1. Select Menu on the home screen.
When making settings after IP address setting, the Advanced screen is displayed. Go to step 3.
2. Select General Settings > Network Settings > Advanced.
3. Select Proxy Server.
4. Select Use for Proxy Server Settings.
5. Enter the address for the proxy server by IPv4 or FQDN format.
Confirm the value reflected on the previous screen.
6. Enter the port number for the proxy server.
Confirm the value reflected on the previous screen.
7. Tap Start Setup.

Connecting to LAN

Connect the printer to the network by Ethernet or Wi-Fi.
Related Information
"Connecting to Ethernet" on page 20
&
"Connecting to the Wireless LAN (Wi-Fi)" on page 21
&
Connecting to Ethernet
Connect the printer to the network by using the Ethernet cable, and check the connection.
1. Connect the printer and hub (LAN switch) by Ethernet cable.
2. Select Menu on the home screen.
3. Select General Settings > Network Settings.
4. Select Connection Check.
The connection diagnosis result is displayed. Confirm the connection is correct.
5. Tap OK to finish.
When you tap Print Check Report, you can print the diagnosis result. Follow the on-screen instructions to
print it.
Network Connection
20