Connecting A Playback Device; Connecting A Playback Device Using A 3.5 Mm Jack Cable; Connecting A Playback Device Using A Cinch Cable - Silvercrest 311937 1904 Quick Start Manual

Connecting a playback device

You can connect a wide variety of playback devices to this device, for
example MP3 or CD players. Please refer to the operating instructions of the
respective device. Switch off all devices before connecting them.
NOTE
► When playing back music via the AUX connections, the
trol are inactive. You can, however, turn the MUTE function on and off using
the
playback device that you have connected.
► Before starting playback, set a moderate volume. When you reach the
maximum volume, you will hear a signal and the volume can no longer be
increased.
Connecting a playback device using a 3.5 mm jack cable
♦ Connect the line-out connector of the external device (e.g. headphone socket)
via a 3.5 mm jack cable to the AUX 1 socket
♦ To switch on the device, press the
♦ Press the
the remote control repeatedly until
♦ Switch on the connected playback device and start playback.

Connecting a playback device using a cinch cable

♦ Connect the audio input jacks R and L
an audio cinch cable with the corresponding audio output sockets on the
external audio device. Make sure that the red and white colour markings
correspond.
♦ To switch on the device, press the
♦ Press the
the remote control repeatedly until
♦ Switch on the connected playback device and start playback.
NOTE
► If both the AUX 1 socket
external playback devices, the music will be played back via the AUX 1
socket
3.5 mm jack cable from the AUX 1 socket
■ 12 │ GB │ IE │ NI
( + ) and (
button . Use the Play/Pause and skip functions on the external
/ FUNC. button
/ FUNC. button
by default. To use the AUX 2 socket
+ ) buttons on the unit and the remote con-
on the rear of the device.
/ FUNC. button
on the device or the AUX button
appears on the display
on the rear of the device using
/ FUNC. button
on the device or the AUX button
appears on the display
and the AUX 2 socket
, simply disconnect the
.
) ,
/ PAIR ( +
or the button
on
.
or the button
on
.
are connected to
SSTB 10 C2
.
.