Switch The Device On/Off; Connecting A Playback Device; Connecting A Playback Device Using A 3.5 Mm Jack Cable; Connecting A Playback Device Using A Cinch Cable - Silvercrest SSTB 10 A1 Operating Instructions Manual

Switch the device on/off
On the device
♦ Press and hold down the
on the device.
♦ Press the
With the remote control
♦ Press the
♦ Press the

Connecting a playback device

You can connect a wide variety of playback devices to this device, for
example MP3 or CD players. Please refer to the operating instructions of
the respective device. Switch off all devices before connecting them.
NOTE
► When playing back music via the AUX connections, the
control are inactive. Use the Play/Pause and skip functions on the
external playback device that you have connected.
► Before starting playback, set a moderate volume. When you reach
the maximum volume, you will hear a signal and the volume can no
longer be increased.
Connecting a playback device using a 3.5 mm jack cable
♦ Connect the line-out connector of the external device (e.g. headphone socket)
via a 3.5 mm jack cable to the AUX 1 socket
♦ To switch on the device, press the
♦ Press the FUNCTION button
the remote control repeatedly until
♦ Switch on the connected playback device and start playback.

Connecting a playback device using a cinch cable

♦ Connect the audio input jacks R and L
an audio cinch cable with the corresponding audio output sockets on the
external audio device. Make sure that the red and white colour markings
correspond.
SSTB 10 A1
button ( ) for approx. 2 seconds to switch
button ( ) again for approx. 2 seconds to switch off the device.
button ( ) to switch on the device.
button ( ) again to switch off the device.
( + ) and (
on the device or the AUX button
+ ) buttons on the unit and the remote
on the rear of the device.
button ( or ).
AUX
appears on the display
on the rear of the device using
GB
+ ) ,
(
on
.
29